Leaperkim Lynx S seat

**Installation Instructions **

Your seat system includes two components: **the Top piece** and **the Base piece**.

1. **Clean the mounting area**
Use isopropyl alcohol to thoroughly clean the top surface of your wheel where the Base piece will be installed.

2. **Open the adhesive promoter**
Tear open the adhesive promoter packet.

3. **Apply the promoter**
Remove the non‑woven applicator fabric and wipe it back and forth over all areas where the double‑sided tape will adhere.
Repeat several passes, then allow the surface to dry for **30 seconds**.

4. **Prepare and install the Base piece**
Remove the thin protective film from the Base piece’s double‑sided tape.
Position the Base piece on top of the wheel.
For best adhesion, lightly warm the tape adhesive using a heat gun or hair dryer.

5. **Align the Base piece**
Ensure the Base piece is properly aligned with the geometry of the top section of your wheel before pressing it down.

6. **Bond the Base piece**
Firmly press all taped areas of the Base piece against the wheel for a couple of minutes to initiate bonding.

7. **Cure time**
Allow the Base piece to remain undisturbed for **24 hours** to ensure a strong, permanent bond.

8. **Attach the Top piece**
Open the cylindrical hook of the Top piece and secure it around the rear handle of your wheel.

9. **Engage the seat**
Push the Top piece downward toward the Base piece until it clicks and locks into place.